Litter Robot 3 Ready Light Blinking. 3. On the Robot Settings page, tap Firmware Information. You will see a single white light blinking on your unit's control panel - this is your signal Illuminated: Waiting and ready for use. Flashing: Time to empty - Waste Drawer is full! Action Needed: Pressing the. Button will
Litter Robot III Connect - Flashing blue light, no buttons work, no start up cycle · Removed the power cable, waited a while, and plugged it back
Red Light Flashing: The Litter-Robot thinks there's a cat that's been in the globe for over 2 minutes, or there's too much weight (too much litter?) in the
Blinkt an Ihrem Litter-Robot 3 die blaue Leuchte? Schalten Sie als erstes Ihr Gerät aus und wieder ein: Prüfen Sie, ob Ihr Litter-Robot mit
If the globe is encountering resistance that is lifting it out of position as it cycles, friction will occur between the plastic of the globe
Litter Robot III - blue light flashing, reset doesn't work · If the unit continues blinking blue, remove the waste drawer and press cycle. · Press
3. On the Robot Settings page, tap Firmware Information. You will see a single white light blinking on your unit's control panel - this is your signal
Litter-Robot 3 flashing red light A solid red light on your Litter-Robot 3 control panel means that the cat sensor was activated by your cat
If the lights on the control panel blink, right to left, left to right or together, the problem is still the same: the robot has failed to track the position of
Illuminated: Waiting and ready for use. Flashing: Time to empty - Waste Drawer is full! Action Needed: Pressing the. Button will
Litter-Robot 3 Connect - Blue Blinking Light · Remove the drawer from the unit and press RESET. · If the unit goes to solid blue, press the CYCLE